Goggles Pizano's latest activity
-
GThe Alley. Search there for thread by user: Lunchbox
-
GGoggles Pizano replied to the thread Front fascia alignment.Good luck. You will be spending hours and hours on this and maybe days. Just read the posts you found.
-
GGoggles Pizano replied to the thread Reverse light wiring..Easier to use a voltage meter or a test light. You could have done that faster then typing your question and found your answer. Safer too.
-
GGoggles Pizano replied to the thread Engine Starts then Stalls Immediately.So your alarm was not disabled.
-
GGoggles Pizano reacted to Viper Specialty's post in the thread Pcm diagram for 1996 Viper Gts with
Like.
Email me what is going on, and what you need @ [email protected] -
GGoggles Pizano reacted to 99RT10GTS's post in the thread 94 Viper right sidepipe overheating and melting sill plate under door. Any ideas as to why this is occurring with Like.
Cut out both cats NOW!!! Get your injectors pulled, checked and cleaned
-
GGoggles Pizano reacted to Old School's post in the thread 94 Viper right sidepipe overheating and melting sill plate under door. Any ideas as to why this is occurring with Like.
Common cause of a cat overheating is a faulty fuel injector dumping too much fuel.
-
GGoggles Pizano reacted to MoparMap's post in the thread 2004 Dodge Viper Gen 3 - lost oil with Like.
I would look toward the cooler lines as well. I replaced mine some time ago with lines I made at home and the fittings failed at the...
-
GSounds more like an oil cooler line. Check the lines above the filter and around the engine block.
-
GGoggles Pizano replied to the thread Hard start when hot.He does.
-
GGoggles Pizano replied to the thread 1994 Gen 1 no clutch resistance.You can always look through the inspection hole and have someone work the clutch.
-
GGearhead is finishing up the exhaust pipes to exit thru the bumper, going to look like a Gen 2 in that regard. Pipes will go maybe 2"...
-
GAnd make sure it is rated GL-*4*, not 5.
-
GGoggles Pizano reacted to GTS Dean's post in the thread Aftermarket Proportioning Valve Install Question with Like.
The 96 manual says it is 1/2-20.
-
GGoggles Pizano replied to the thread carbon fibre bonnet - stay arm.Too simple.
