GTS Dean's latest activity
-
GTS Dean reacted to Steve-Indy's post in the thread Priming Motor that sat for 6 months. Did I screw up? with
Like.
You may get dozens of answers here...some factual, some fanciful, and everything in between. Today's quality full synthetic oils offer... -
GTS Dean replied to the thread ACR Koni Shock Manual Supplement.The Koni 2812's are great shocks. They are properly valved and sprung for the application. Before you remove the shocks, give the...
-
GTS Dean replied to the thread ACR Koni Shock Manual Supplement.Thank you Bob. That's exactly how I set my ride heights. 4-5 inches is a good range. You want roughly 1/2" rake in the chassis front-rear.
-
-
Viperwerks.com owns the molds for the LEmke hardtops. Jeff sold them to us years ago along with the street serpent molds. Lemke hardtops...
-
GTS Dean replied to the thread ACR Koni Shock Manual Supplement.As you lower the ride height, negative camber will increase (tires lean in at the top). I always adjust my shocks to 0-0 on bump-rebound...
-
GTS Dean replied to the thread The Quest for 275 MPH.Antifreeze.
-
GTS Dean replied to the thread Leaking valve cover gasket, even after replaced?.You must not be very old. I've see a number of stamped seel VCs on cork gaskets that were warped out of plane, or cast covers that were...
-
What they mean by water content is the fluid has hydroscopic properties (absorbs moisture). For brake fluid, that can be a safety issue...
-
GTS Dean replied to the thread Replace or not?.Change your coolant, grease your ball joints, change plugs and wires, drive carefully while you source new tires. Enjoy!
-
The ice boxes are located behind the rear wheels, 1 on each side. The cap to load them is inside the rear hatch. I estimate about 8 gals...
-
GTS Dean replied to the thread The Quest for 275 MPH.Where are the hatches to load the ice? Will you use dry, or water ice? How does the cold side plumbing get from back to front?
-
GTS Dean replied to the thread Leaking valve cover gasket, even after replaced?.Something is not straight/level, or damaged.
-
GTS Dean reacted to kmagnuss's post in the thread Leaking valve cover gasket, even after replaced? with Like.
I think I have it figured out. I started looking around again this am and got a camera in there and saw that there was about a 1" long...
-
GTS Dean replied to the thread Leaking valve cover gasket, even after replaced?.I had a similar issue a few months ago - same side. Turns out it was a bolt hole at the lower rear corner hat had some crud in it and...
-
All the hoses are finished to include fuel, nitrous, catch can, intercoolers, pumps, oil lines, scavenge pump, etc. Battery disconnect...
Latest posts
-
-
-
-
New 99 RT/10 owner, few questions on issues/coilovers.
- Latest: Goggles Pizano
-
-
-
-
