GTS Dean's latest activity
-
GTS Dean replied to the thread Aftermarket Proportioning Valve Install Question.There's a schematic line diagram of the system from MC to calipers. It lists the connection thread size by callout. -
-
GTS Dean replied to the thread Aftermarket Proportioning Valve Install Question.The 96 manual says it is 1/2-20.
-
GTS Dean replied to the thread Transmission Fluid for G1 & G2.And make sure it is rated GL-*4*, not 5.
-
GTS Dean reacted to Tom and Vipers's post in the thread Roe VEC1 Technical Questions: 12v source revision, Key-On BARO, 12v Vampire Piercing Connectors with
Like.
UPDATE: FYI: The 12v VEC1 & Air Fuel LED Display piercing connector tap had failed and was "barely" intermittent (meaning mostly... -
On my 1999 GTS, the service manual says to use ATF +4 , so I use Amsoil multi vehicle full synthetic trans fluid that's there top of the...
-
GTS Dean reacted to Bob Woodhouse's post in the thread Aftermarket Proportioning Valve Install Question with Like.
Great response there GTS Dean. You and I have been down this road, since you have owned and raced your car since the beginning in 1996...
-
Far too many times we don't always recognize positive experiences when dealing with companies. Last week I decided to pull the trigger...
-
GTS Dean replied to the thread Aftermarket Proportioning Valve Install Question.To disable the proportioning section of the OE Combination Valve: remove the nut at the back, (it's tight!) remove the spool valve and...
-
GTS Dean replied to the thread Roe VEC1 Technical Questions: 12v source revision, Key-On BARO, 12v Vampire Piercing Connectors.Way ahead of you there.
-
-
any decent high flow cat. i have belanger ceramic on my gen 2
-
GTS Dean reacted to Viper Specialty's post in the thread Car will not start unless fuel pump unplugged first with Like.
Battery and/or battery related connections. Crank fueling is both voltage offset and temperature based, and base offset reference and...
-
GTS Dean replied to the thread Roe VEC1 Technical Questions: 12v source revision, Key-On BARO, 12v Vampire Piercing Connectors.I have Z-E-R-O faith in those Scotch-lock taps. The conductors on our cars are already somewhat marginal and anything that compromises...
-
Leaking at the quick connector. The oring inside the fitting is bad. I bought some an6 fittings and tubing, will make new hose. Thanks
-
Here is a pic of the hatch area pretty much finished along with the toe lift in event throttle cable sticks wide open. It's so close to...
Latest posts
-
-
-
-
New 99 RT/10 owner, few questions on issues/coilovers.
- Latest: Goggles Pizano
-
-
-
-
