Sean Roe's hose.....

[Newport Viper]

Sean Roe\'s hose.....

kit. Has anyone taken pictures of it (Gen 1) installed? I am looking for the red kit. Would also like to see heater hose pic's.
Thanks!
Would it be a good time for a new water pump? 40,000 miles on old one. How much are they?

 

[2tall]

Re: Sean Roe\'s hose.....

I was thinking of something ENTIRELY different.

 

[Bad_Byte]

Re: Sean Roe\'s hose.....

If you're referring to "radiator" hoses I just installed a set. If you work on your own car its not too awful but there is one small trick I found that made it a lot easier. Remove the windshield wipers and the facade beneath them (4 screws) this so you can get to the two short hoses in the rear of the engine. That's all. The rest were just like any other hose. Ya seen one hose Ya seen them all...While your at it I would flush the engine block as well. That was the fun part.

Now if I can figure out how to get the air out.

 

[Newport Viper]

Re: Sean Roe\'s hose.....

Thanks!
Anyone else with opinions on how they look?

 

[ExecUtron Technologies]

Re: Sean Roe\'s hose.....

Here is a picture of a '95 Gen-1 with red hoses from Roe:

You must be registered for see images

 

[Jay Herbert]

Re: Sean Roe\'s hose.....

<BLOCKQUOTE><font size="1" face="Verdana, Arial">quote:</font><HR>Originally posted by Bad_Byte:
If you're referring to "radiator" hoses I just installed a set............. Now if I can figure out how to get the air out.

<HR></BLOCKQUOTE>


I thought these had an air bleeder built into them?