Search results
-
B
09 Viper or Modify Existing One???
No brainer---is the 05 paid for? If so---keep it!!- Bandit3
- Post #37
- Forum: SRT10 and SRT10 Coupe Discussions
-
B
XM Radio
FLL-- yup, works great! John I had Circuit City do the install.- Bandit3
- Post #5
- Forum: SRT10 and SRT10 Coupe Discussions
-
B
XM Radio
I have an 06 coupe. My XM receiver is at the bottom of the "A" pillar above the dash, mounted to the windshield with a suction cup mount. The antenna is on the top of the dash just above the speedometer. It is not secured, but stays in position and can not be seen from the drivers seat. I bought...- Bandit3
- Post #2
- Forum: SRT10 and SRT10 Coupe Discussions
-
B
Hennessey 600 Running Like Sh......t
Check engine vacuum--probably very low at idle if the cam has a lot of overlap. Check around 2500 RPM, should be about 15-19 inches of mercury ( if this is a lil off, someone chime in, been a long time since I've needed to do this). This test will show low, too high ignition problems, or loss of...- Bandit3
- Post #36
- Forum: RT/10 and GTS Discussions
-
B
Aghh!!! Clutch Problem... HELP
Yes, that'll work too! And not as messy.- Bandit3
- Post #18
- Forum: RT/10 and GTS Discussions
-
B
how to go back to "stock"
jdeft1, why not have it tested first to see if it will pass/fail? After if it does fail, they will inform you of the repairs necessary. John- Bandit3
- Post #6
- Forum: RT/10 and GTS Discussions
-
B
Aghh!!! Clutch Problem... HELP
Along these lines, always bench bleed a master cylinder for either the brakes or the clutch. John- Bandit3
- Post #16
- Forum: RT/10 and GTS Discussions
-
B
Aghh!!! Clutch Problem... HELP
Rob, these are all good suggestions. If it's not too much trouble--remove the master cylinder and bench bleed it first. This will make the bleeding of the line and slave faster. This can be done by placing the master in a vise--holding on to the bolt lug only--not the body. Using a punch or...- Bandit3
- Post #15
- Forum: RT/10 and GTS Discussions
-
B
Euro Tech rotors---wow
Is that little guy holding up the car or hanging from the engine compartment?- Bandit3
- Post #13
- Forum: SRT10 and SRT10 Coupe Discussions
-
B
Euro Tech rotors---wow
Hey, they look just like mine! Thanks for the picture and the directions to post pictures.- Bandit3
- Post #10
- Forum: SRT10 and SRT10 Coupe Discussions
-
B
Euro Tech rotors---wow
LOL, if I could, I would, I am the original computer dummy.- Bandit3
- Post #4
- Forum: SRT10 and SRT10 Coupe Discussions
