Search results

  1. S

    Pair NOS rear quarter panels for gen1/2 - in factory boxes 92-02

    Hello, I am restoring a 92. I didn’t think I was going to find a pair of 92 rear quarters with the antenna hole. However, I actually did. This was after I bought a pair of rear quarter panels for it. They are in the factory mopar boxes. The boxes and both the right and left rear quarter panels...
    • Samhane1
    • Thread
    • gen 1 gen 2 gen1 gen2 nos panel quarter quarter panels
    • Replies: 0
    • Forum: Classifieds
  2. S

    Front Chin bumper scraping problem

    This might not be a permanent fix but at least it helps with the scraping. I purchased vinyl the same color as my car. Jacked it up and laid it on there. Depending on how you lay it you really can’t tell it’s even there. But it actually goes a long way for protecting it. Depending on how...
  3. S

    2000 Viper turns over - wont start P1389 Code

    Hey Steve/Jim, I appreciate all the help. 15 amp fuse is fine. The 20 amp blows!! it was the wire going to the o2 sensors. I found the short right at the frame!!! I am back up and running. Thank you very much for all your help!!
  4. S

    2000 Viper turns over - wont start P1389 Code

    Hello Steve, You were correct, it is blowing the 20 amp #15 pcm/asd every time I try to start it. Is there a name for these larger type fuses? Do these feed the O2 sensors? thanks
  5. S

    2000 Viper turns over - wont start P1389 Code

    I can connect to the PCM to pull the code. The ASD relay is good as well as the PCM. I swapped them both. How frustrating!! :-)
  6. S

    Mechanic needed in NC - Greensboro area?

    Thank you both! I will look into it!
  7. S

    Viper Community Part Resource Project

    Will have the first release of the site in the next few weeks. I will post a link to it. Looking for any input on ways we can make it more useful, features to include, etc. Site will be ad-free.
  8. S

    Sourcing Obsolete Parts For Gen I and Gen II Vipers

    Looking for GEN1/2 headlights. Trying to finish a GTS/ACR project. Will pay well! :)
  9. S

    Mechanic needed in NC - Greensboro area?

    The local dealership here doesn’t have any certified Viper technicians. I was hoping someone could recommend someone in the area. Greensboro, Charlotte, Raleigh - NC area! Tom Sessions is always a good bet but he is usually swamped! Thank you!
  10. S

    2000 Viper turns over - wont start P1389 Code

    Hey Steve, I did swap that relay with the low beam 20 amp right next to it. That’s the one that I swapped with and it started up for a second and then died. Any other suggestions? Thank you!
  11. S

    2000 Viper turns over - wont start P1389 Code

    The O2 sensor wires look good. I didnt look at the PDC Fuse. I will go check it out now. I appreciate it - will report back!
  12. S

    2000 Viper turns over - wont start P1389 Code

    I was hoping to get some guidance. I just purchased a Gen2 and it was running fine. It would fire right up and run great. I pulled it out of the garage to do some cleaning. When I tried to pull it back into the garage - it wouldn’t start. It turns over but won’t start. When I scanned the car, it...
  13. S

    Viper Community Part Resource Project

    Hello Viper community! I am new to the viper community but want want to give back. I have a GEN3 and just purchased a GEN2 that needs some help - airbags, etc. Anyhow, I quickly found out how difficult it is to source parts. I started building a website that lists all the parts, replacements...
  14. S

    Sourcing Obsolete Parts For Gen I and Gen II Vipers

    Hello, Does anyone know where I could find a hood release handle? Mine broke.
  15. S

    1995 Viper New Battery - starts fir a few seconds and dies!

    Hello, I will try to be complete as possible. I was driving the car and noticed the battery light came on. Pulled into the garage snd shut it off. A few days later….It won’t start. Or if it starts it will run for a few seconds and die. Sometimes the flashers blink on and off. I replaced the...

Latest posts

Members online

Total: 754 (members: 1, guests: 753)

Forum statistics

Threads
153,647
Posts
1,685,251
Members
18,224
Latest member
dave777

Share this page

Top