Anyone using a shift light?

[RTED]

Anyone using a shift light? If so, how difficult was it to connect to the tach source?

 

[Alternative]

Here's one result you'll get when you use the "search" feature on this site:

http://vca2.viperclub.org/forums/showflat.php?Cat=&Board=UBB14&Number=499529&Forum=UBB14&Words=shift%20light&Match=And&Searchpage=0&Limit=25&Old=3months&Main=499529&Search=true#Post499529

 

[Woody]

The Raptor in Alternative's post works great. I had my Viper Tech install it so I am not sure how difficult it is to install.

 

[B SNAKE 1]

I have a raptors shift light it took me about a hour to install! works great

 

[Rocket65C]

Easy install, but confirming which is the correct wire takes a bit of detective work.

 

[RTED]

Thanks guys for the information on the Raptor shift light. Just ordered one

 

[RTED]

What are the difference in the install instructions for a GEN I vs. GEN II if any??

 

[Joseph Dell]

On the raptop, you don't hook up to the "tach" wire... you hook up to a coil wire @ the PCM... but once you figure this out, then you are fine.

here is a pic of the raptor light installed:

JD

 

[RTED]

Why would the hookup on a ragtop be different than on a GTS??

 

[Jack B]

The nice thing about the Raptor light is that you can adjust the rpm point right on the light. the second item is that there is no additional box to mount as with the other lights.

 

[AJT]

I have one that I ordered but haven't installed yet. Are you soldering the wire to the coil wire or are you splicing it in? If you are soldering it are you doing it at the connector or farther up the wire?

Andy