Belangers help needed.

[TacDoc]

Four hours so far to strip old exhaust block to rear, one hour a day, so taking care not to gimp anything. I have run into a problem. The two sections of drivers side header slipped in from the top without a problem, practically dropped right in. The passenger side is a different story. The blower fan is right in the way (the top section has already been removed). Should I be putting this side (passenger) in from the top or bottom?

 

[TacDoc]

Thanks Neil. I just spent 30 minutes trying every imaginable way to get the things in from the bottom, no way. Time to disassemble some more.

 

[TacDoc]

That was the trick Neil. Pulled the blower motor and the passenger side header fell right into place. Tomorrow every thing starts going back together. Can't wait to hear it.

 

[Neil - UK]

glad to help as others did for me when fitting, I'm sure it will sound awesome

 

[Neil - UK]

stuck in mine from the top, remove the spinning fan as well
below the top section of the A/C box, remove about 3 bolts that hold the coolant bottle and unclip the pipes infront of it, this will allow it move slightly out of the way, giving a bit more room. This side is a lot tighter so apply lots of masking tape to your valve covers to avoid scratches