Clear vinyl guard for bottom lip of front fascia, anyone seen one?

[99VPRGTS]

About a year ago on ebay, for around $35, there was a precut vinyl guard that wrapped around the bottom lip of the front fascia. Like an idiot, I didn't buy 10 of them lol. Anyway, has anyone seen these or know where to pick one up or something similiar? The thing was perfect...went up about 3/4 of an inch and from the pics it looked like it fit really well. Thanks!

EDIT: This was much thicker than any clear bra material, but still thin enough to look good.

 

[ViperTony]

McMaster-Carr has this material. I'll look up the part#/specs but I put it on my winter mod project. It's the same 3M material Griot's sells but cheaper from McMaster. I'd need to cut it to fit (corners) but that's not a problem for me.

 

[Matt M PA]

Perhaps not what you're thinking about....and hopefully I'm not breaking rules

I used to sell a piece of molding on eBay that was a "U" channel which could be pushed onto the bottom lip of the Gen 2 fascias. It came up about .25 of an inch to protect that bottom edge from scrapes. It has a caulk inside the channel to help keep it on. There's been one on my '00 GTS since new. When one gets scraped...I put another on.

Is this what you remember?

[media]http://i26.photobucket.com/albums/c118/MattMPA123/DSC00021.jpg[/media]

 

[vipergtsinnova]

Perhaps not what you're thinking about....

I used to sell a piece of molding on eBay that was a "U" channel which could be pushed onto the bottom lip of the Gen 2 fascias. It came up about .25 of an inch to protect that bottom edge from scrapes. It has a caulk inside the channel to help keep it on. There's been one on my '00 GTS since new. When one gets scraped...I put another on. I think they were listed for $20, shipped. (I probably should list them again as I sold a bunch)

I'll take 2... email or PM me

 

[CWhiteRun]

Perhaps not what you're thinking about....and hopefully I'm not breaking rules

I used to sell a piece of molding on eBay that was a "U" channel which could be pushed onto the bottom lip of the Gen 2 fascias. It came up about .25 of an inch to protect that bottom edge from scrapes. It has a caulk inside the channel to help keep it on. There's been one on my '00 GTS since new. When one gets scraped...I put another on.

Is this what you remember?

[media]http://i26.photobucket.com/albums/c118/MattMPA123/DSC00021.jpg[/media]

If you have any spares laying around then I'd like to snag one as well. I believe one of these (or something similar) was on the car when I bought it, but a possum wound up taking it out for me on the interstate.

 

[Matt M PA]

Those that asked for ***....have them.

 

[sdaddy]

I used some clear door edge guard to try this, but it was a miserable fail. I was looking for something flexible enough to go to the outside edge of the fascia where I really seem to get the most scrapes, but it would not make the curves.

 

[white out]

I have it. It gets beat up, but I seem to be the only one who notices it.

Nick

 

[Venomiss]

We had a vendor come to VOI11 callled Trac Wrap.

You can read about them here.

Tracwrap Events: Come See Our Paint Protection in Person | Tracwrap

Didn't know if this was similar to what you are looking for.