DTC Code P0157 on my 06 S/C Roadster

[ViperCobra]

Hey Guys,

Just want to ask if this code should be addressed and fixed right away. It came on and checked it with my handheld device and showed this code on my 2006 Supercharged SRT 10 Convertible. I deleted it with my device but it showed up again about a week after deleting it. Any opinions suggestions much appreciated... Thank you

 

[Westxsrt10]

o2 sensor...maybe caused by a burned wire. The code reader should tell you which bank L/R and what number 1 or 2.

 

[AbsolutHank]

That should be pass side rear...do you have headers?

 

[ViperCobra]

That should be pass side rear...do you have headers?

I don't have headers just the stock ones. Is this an easy fix? Thank you for the replies

 

[ViperCobra]

Any more comments/suggestions? Thanks Guys

 

[Westxsrt10]

I don't have headers just the stock ones. Is this an easy fix? Thank you for the replies

Remove the pass. side sill for access. One 10mm bolt is hard to get at (top fender vent, 1 hour job)

 

[ViperCobra]

Remove the pass. side sill for access. One 10mm bolt is hard to get at (top fender vent, 1 hour job)

Thank you Sir. After I access to it what should I do? Sorry, not a car guy

 

[Westxsrt10]

Thank you Sir. After I access to it what should I do? Sorry, not a car guy

Replace the sensor...... and or check for a bad or burnt wire.
If you are not a DIY'er/CarGuy don't mess with it.

 

[ViperCobra]

Replace the sensor...... and or check for a bad or burnt wire.
If you are not a DIY'er/CarGuy don't mess with it.

I may have to just go to a shop and have it done. Can the Dodge dealer service fix it?

 

[NO HEMI]

They probably can, they should have a "vipertech", if they can sell vipers.

 

[Garron]

I don't have headers just the stock ones. Is this an easy fix? Thank you for the replies

if the exhaust is stock you do NOT have to remove the sill. You can get to the sensor from under the car.

 

[ninjakris]

if the exhaust is stock you do NOT have to remove the sill. You can get to the sensor from under the car.

Good point. Get the car up on a lift. It can be a 5 minute job if its a simple loose connector or you just replace the O2 censor. You can do it with the car lifted up on a jack and stands but its a little tight.

 

[SEEEEYA]

Seems like this is happening to alot of guys, I'm in the same boat, only 4k on 06 roadster, Po156 code, passenger side 02 sensor