Emblem placement, 2003 SRT-10

[KDR83]

My car came debadged and I want to put the emblems back on and just got them in but need instructions on placement.

Can someone please measure how far the bottom of the side emblems to the crease is? From either the bottom of the S T or 1 0 in SRT-10, I believe it is 3/4ths of an inch. Also can you do the same how far it is to the front edge of the panel to the furthest left side of the V? I believe it's 2 inches but just want to confirm.

Also how far from the bottom of the "dodge" emblem on the right side of the back bumper to the lip/crease (not the one part of the diffuser) on the rear bumper and same goes for the "viper" logo on the left side from the bottom of the center section of the emblem, the I P E and part of the R, I feel like I can put a piece of tape and align that portion of the emblem more easily.

This should only take you a couple minutes and would greatly help me!

Thanks

 

[AbsolutHank]

I'm outta town but will do it for you Sunday when I get home if no one replies by then

 

[KDR83]

I'm outta town but will do it for you Sunday when I get home if no one replies by then

Thanks! the rear probably is a little different but the front should be the same

 

[prpaster]

You must be registered for see images attach

You must be registered for see images attach

You must be registered for see images attach

You must be registered for see images attach

You must be registered for see images attach

in cm

 

[KDR83]

Thank you so much, that is in centimeters just to double check right?

 

[prpaster]

Yep that is in centimeters

 

[prpaster]

2.54cm in an inch if you want to convert

 

[KDR83]

Haha thanks