Gen 1 - installing teamtech harness

[viper067]

Fairly simple question ... Have all the eyebolts installed except the drivers door bolt which I can't seem to find the hole

So I have to cut the slots in the bulkhead for the belts to pass through, what is the preferred method? Drill and jigsaw? Dremel? Multitool?

I dislike cutting holes in the car and would like the nicest possible outcome

 

[TexasPettey]

If you are talking about the lower bolt for the belt strap, it's there under the carpet. I'm not in front of my car now, or I'd snap a pic for you.

 

[viper067]

Found the bolt hole, it was much lower than I expected it to be. Should have just looked where the passenger belt is bolted.

Used a fein multitool to cut the bulkhead and a dremel with grinder tip to clean it up.

Now bring on the track days no more spending to much energy holding on instead of driving.

 

[TexasPettey]

Do you have a racing seat? If not, that's the best combination with a harness. That combination makes a huge difference.

 

[viper067]

Just using the stock Gen 1 seat