Gen 3 Baseline Dyno

[dcvickers]

I've had my Viper for about 3 weeks now and I've been itching to get a baseline dyno before I have to put it away for the winter and start on the mods. So, I went to a dyno shootout last night. Numbers were a little higher than I expected. Final run was 450/490. I was amazed at the amount of torque available throughout the RPM range. My Vette had 410rwtq but it didn't go above 350-375 until 4500 rpm. Anyway, here's the dyno sheet. Enjoy!

You must be registered for see images

 

[swexlin]

That's about where the numbers should be for a stock Gen 3.

 

[Jeebs]

Not bad numbers. Right where they should be. So whats your plans for it during the winter?

 

[dcvickers]

Not bad numbers. Right where they should be. So whats your plans for it during the winter?

Probably going to go with some M&M headers and a Corsa exhaust. Anything else I should consider that won't completely empty my wallet?

 

[swexlin]

Go for the all out twin turbo!

 

[dcvickers]

Go for the all out twin turbo!

Eventually I'm going to get a paxton or go TT. They're just a ways down the road...

 

[Chemeng]

Find a wrecked Veyron and do a quad turbo. Sleeping in a bed every night is highly overrated.

 

[ViperCobra]

Good numbers ... Congrats! Paxton next ....

 

[dcvickers]

Find a wrecked Veyron and do a quad turbo. Sleeping in a bed every night is highly overrated.

Hmmm...

Good numbers ... Congrats! Paxton next ....