Gen III Intake manifold removal

[1HOTV10]

I am installing a new set of Ignition wires . Any heads up on the R/R of the intake manifold?

 

[ACPERFORMANCE]

It's real straight forward if you just take your time. It will take a little bit of time to do, and some bolts may be a little harder than others to get to, just be patient.

Todd

 

[Racer Robbie]

You can reuse the intake manifold gaskets if you like, but considering the time it takes to R & R the intake manifold, I would replace them. Here is the part number from Mopar.

5037-217AC​

​

​

​

​

INTAKE MANIFOLD GASKETS, Qty 2 needed​

​

​

​

​

 

[1HOTV10]

Thanks for the info!
Ordered them up from Mopar
Strange that the gaskets are sold as an each and not as a pair.

Glenn..........

 

[Racer Robbie]

That's Mopar for you!

Thanks for the info!
Ordered them up from Mopar
Strange that the gaskets are sold as an each and not as a pair.

Glenn..........

 

[viperbilliam]

Thanks for the info!
Ordered them up from Mopar
Strange that the gaskets are sold as an each and not as a pair.

Glenn..........

I don't think so - Murphy's Law, screw-up, lost one, etc....sometimes only one is needed. I have fubbed up a gasket in the past and learned what I should have done but it's annoying to buy two when you only need one!