Plugwire Looms

[V10 MOJO]

anyone offer a metal plug wire loom? billet polished would be nice

 

[GTS-ACR]

That would be cool. Does anyone know where I can get 10 mm looms?

 

[Steve-Indy]

Sure that you want metal loom ?

 

[Vip-RT10]

http://www.kingsborne.com/2fs.htm

 

[V10 MOJO]

thnx Vip RT10 but they dont sell them. they have nice wires though.

i guess ill just take on of the cheap plastic looms to a machine shop and see if they can do a set

 

[KenH]

I considered making metal looms for my 10mm wires, but I was worried that there would be too much risk of creating an arc to ground unless they were heavily insulated. Course the 10mm may have enough insulation where it wouldn't matter. Would look good though.

--- Ken

 

[Fast Viper Dan]

Call Moody Mfg. in California. Ask for Dan 408-982-9137.
Make a paper layout of what you want and I will build them.
They can be polished or anodized. Black,Blue,Red,Gold.
Keep in mind the Anodize is a $75.00 minimum lot charge.
If there is a demand for, say 10 sets, this would help keep the cost down. I hesitate to estimate the cost with out seeing a sketch only to be fair. This is not meant to be an add but a Viper Club Resource.
We (not I) built some for our Panoz and we have not had any shorting. They look clean and hold the wires down with wire ties (any color).
I normally build Space products but this is the fun stuff.
Dan

 

[Vip-RT10]

That site does have the 10mm wires though, but I would be concerned about the arcing as well.

 

[Jack B]

V10MOJO:

it might look nice, however, you are looking for trouble. You want to insulate the wires from the block, not, electrically attach them to the block.