Power Window Adjustment problem

johniew398

Enthusiast
Joined
Jun 1, 2008
Posts
1,260
Reaction score
0
Location
Bentonville, Arkansas
I have an 08 ACR. Recently the passenger side power window wants to travel up too far/high.

I searched the forum for similar issues and fixes since there wasn't anything in my manual. Most of the references are for models prior to 08 and
talk about have to take off the door cover and adjust with a torx wrench or in some cases a control module going bad.

On any other vehicle this would be a "memory" issue and you would be told a series of steps to adjust the travel.

I can't believe it is this much trouble even if our cars are hand built.
 

rukcus

Viper Owner
Joined
Apr 18, 2012
Posts
127
Reaction score
0
Location
Toronto
I have read that if you hold down the power window switch until the window goes down all the way and continue to hold for an additional 3 seconds it recalibrates the travel. This problem occers after the cars battery has gone flat for a while.
 
OP
OP
johniew398

johniew398

Enthusiast
Joined
Jun 1, 2008
Posts
1,260
Reaction score
0
Location
Bentonville, Arkansas
I have read that if you hold down the power window switch until the window goes down all the way and continue to hold for an additional 3 seconds it recalibrates the travel. This problem occers after the cars battery has gone flat for a while.

THANKS. I am going to try that. My battery is probably five years old and I am going to replace it when I change the oil this next time.
 

rukcus

Viper Owner
Joined
Apr 18, 2012
Posts
127
Reaction score
0
Location
Toronto
Have you left your car without a battery for a while or have you had to boost it after a long time of storage? Because if your battery has been fine without issue then I don't think replacing it right away is the solution.
 

Brian E

Viper Owner
Joined
Oct 2, 2000
Posts
505
Reaction score
1
Location
Granger, Indiana, USA
To index the Viper windows, try this:

1) Get in car and close the door.
2) Turn the key on to the second position. Don't start.
3) Cycle window down and hold switch for 5 seconds and release.
4) Cycle window up and hold switch for 5 seconds and release.
5) Repeat 2 more times.
 
OP
OP
johniew398

johniew398

Enthusiast
Joined
Jun 1, 2008
Posts
1,260
Reaction score
0
Location
Bentonville, Arkansas
Have you left your car without a battery for a while or have you had to boost it after a long time of storage? Because if your battery has been fine without issue then I don't think replacing it right away is the solution.

I haven't had battery problems and won't replace it for this problem. It's just that I have had the car for four years meaning the battery is five or more years old. Want to replace the battery before I have any issues.
 
OP
OP
johniew398

johniew398

Enthusiast
Joined
Jun 1, 2008
Posts
1,260
Reaction score
0
Location
Bentonville, Arkansas
To index the Viper windows, try this:

1) Get in car and close the door.
2) Turn the key on to the second position. Don't start.
3) Cycle window down and hold switch for 5 seconds and release.
4) Cycle window up and hold switch for 5 seconds and release.
5) Repeat 2 more times.

Ok, will try that.
 

dcvickers

Enthusiast
Joined
Sep 10, 2012
Posts
119
Reaction score
0
To index the Viper windows, try this:

1) Get in car and close the door.
2) Turn the key on to the second position. Don't start.
3) Cycle window down and hold switch for 5 seconds and release.
4) Cycle window up and hold switch for 5 seconds and release.
5) Repeat 2 more times.

Has anyone ever actually confirmed this is how to get the window indexing to work again? I took this same advice and it ended up being the "straw that broke the camel's back" for both window regulators (the added stress from holding the button down caused the plastic to pop out of the joint). I installed new regulators in each door and, lo and behold, the windows indexed without me having to do anything.
 

Lespauldude

Viper Owner
Joined
Dec 14, 2010
Posts
427
Reaction score
0
Location
Kings Park, NY
Has anyone ever actually confirmed this is how to get the window indexing to work again? I took this same advice and it ended up being the "straw that broke the camel's back" for both window regulators (the added stress from holding the button down caused the plastic to pop out of the joint). I installed new regulators in each door and, lo and behold, the windows indexed without me having to do anything.

If I were you, I'd give a shout out to Chuck Tator (The Viper Wizard) on this. I'm sure he could set you straight.
 
OP
OP
johniew398

johniew398

Enthusiast
Joined
Jun 1, 2008
Posts
1,260
Reaction score
0
Location
Bentonville, Arkansas
Has anyone ever actually confirmed this is how to get the window indexing to work again? I took this same advice and it ended up being the "straw that broke the camel's back" for both window regulators (the added stress from holding the button down caused the plastic to pop out of the joint). I installed new regulators in each door and, lo and behold, the windows indexed without me having to do anything.

Ok, I will wait and let the dealer try to fix it. I don't need any more problems than I already have.
 

Brian E

Viper Owner
Joined
Oct 2, 2000
Posts
505
Reaction score
1
Location
Granger, Indiana, USA
I had to perform this procedure on both my 2004 and 2010 after disconnecting the battery. Works as described. If your regulator is bad/going bad, thats a whole different story and indexing will not resolve your issue. I would certainly try indexing my windows before taking it to the dealer for repair, but I don't have much confidence in my local dealer.
 
OP
OP
johniew398

johniew398

Enthusiast
Joined
Jun 1, 2008
Posts
1,260
Reaction score
0
Location
Bentonville, Arkansas
I had to perform this procedure on both my 2004 and 2010 after disconnecting the battery. Works as described. If your regulator is bad/going bad, thats a whole different story and indexing will not resolve your issue. I would certainly try indexing my windows before taking it to the dealer for repair, but I don't have much confidence in my local dealer.

Sounds good. Didn't have time to do that last night; but, will.
 

Mopar Steve

Enthusiast
Joined
Oct 27, 2000
Posts
2,871
Reaction score
0
Location
Newark DE
The indexing procedure works for me. My hard top and soft top are contoured a little differently. Not much but just enough to make a difference. When I use the hard top, I do this process and it only takes a few seconds and it is done.
 

bluesrt

Enthusiast
Joined
Nov 17, 2008
Posts
5,011
Reaction score
3
are your outside black window stops ripped in the corners, you will never fix the problem with these damaged, and they are prone for this
 

mrcodeman4

Enthusiast
Joined
Oct 24, 2024
Posts
9
Reaction score
1
Location
Waco, Texas
For those looking for examples. This window exercise of indexing did not solve the problem on my driver side window not going down far enough when the door handle is engaged. For the time being, it also did not break the regulator.

I will be putting a thin strip of PPF on the danger area in hopes it prevents further paint damage.

2006 Coupe
 

Latest posts

Members online

Forum statistics

Threads
153,618
Posts
1,685,011
Members
18,185
Latest member
TeslaCoil
Top