Autoform Rollbar Installation

[NascarDave]

Anybody installed the autoform rollbar on an R/T? I need some advise as I can't get the replacement bulkhead cover to fit at all. It looks like crap or at least not worthy of being in a Viper. Any tips or tricks?

Thanks in advance,

DN

 

[Bad_Byte]

Yep, you're right. It didn't fit in mine either. I had to take a grinder to the middle hole grind it out and monkey around a lot to get it to even install. The best I can offer is that at least the original bulkhead piece is still entact.

 

[Mark Red GTS Cooper]

I have a autoform roll bar, and I used the existing panel, I had to do some real serious cutting and fab, but it came out great. If some one can host a few pics, I can show you,

Mark

 

[NascarDave]

Mark and Bad Byte,
Thanks for the replys. Mark, if you could e-mail those pics to me, I'd very much appreciate it.

Thanks,
Dave

 

[Supercharged Vipermad]

I have a autoform roll bar, and I used the existing panel, I had to do some real serious cutting and fab, but it came out great. If some one can host a few pics, I can show you,

Mark

Send me those pix Mark!! I'll pt them up.

 

[V10 MOJO]

sure wish someone could find that roll bar that was allegedly made by a Blak Racing out of Dallas Tx. i forget who had it but it was on a silver rt10 with custom striping and it looked better than ANY rollbar out there

 

[Supercharged Vipermad]

Here you go...Mark's images:

 

[Ulysses]

Wow! That is some serious cutting!