hood pad painting--tips needed

[SNKBYT]

I was thinking about painting the Viper hood pad emblem. What needs to be done to prep it? It is a porous material. Does it need to be sealed first? Special paint? I would love to hear from some first hand experience before I try it. Thanks

 

[GTSnake]

It is very porous. Just mask it off with masking tape cut around the logo and spray away. I used 5-7 coats of paint to get it looking solid. I didn't use primer but you may want to use some to save paint.

 

[GTSPOWERED]

Mine fish eyed very bad and I had to use a fish eye remover. I think that it was because of the oil vapor from the engine.

 

[RAYSIR]

I agree with GT. just be careful if using a razor to cut out. Use an exacto knife. No need for primer because it would stick.
ALSO, saw your handle and my first thought was I didn't post that message. I tried to get SNKBYT here but said was used so I thought from when I was on a few`yrs `ago. Even my hotmail addy. And RT10 plate. TOOO Funny.

 

[jaydoc1]

Here's the procedure start to finish:

http://www.reefcorner.com/Viper/paint_liner.htm

At least the procedure this guy used.

 

[jcaspar1]

I did the exact procedue in the post above and it still looks great 2-3 years later. Used same paint.

 

[JUCD VPR]

Sweet great idea guys. I'm going to do mine as soon as i get back stateside!