Snake Bitten
Enthusiast
Does anyone who has lowered their snake have a pic of the machined down spring caps? Danke Vielmals!
Need pic of machined spring perch / cap
- Thread starter Snake Bitten
- Start date
GTS Dean
Enthusiast
Gimme a few hours.
Snake Bitten
Enthusiast
Dean...You're the man!
GTS Dean
Enthusiast
Here you go. Any competent machinist should be able to mill about 6mm (0.25") off the mating surface. However, your car *may* already have the reduced height spring retainers on it from the factory. A standard perch has about 3/8"+ of margin down from the angled cap.
You must be registered for see images
