PCV Grommet alternatives?

[Suregrip391]

Hi Guys, are there any other alternatives to the PCV grommet #5245322 that is discontinued through Dodge? Specifically, 97 GTS. Thank you.

 

[GTS Dean]

Here's a very carefully kept secret: the Chrysler Corporation has used EXACTLY THE SAME PCV GROMMET FOR ALL ENGINES SINCE 1967.

Shhhhhhh!

 

[daveg]

Here's a very carefully kept secret: the Chrysler Corporation has used EXACTLY THE SAME PCV GROMMET FOR ALL ENGINES SINCE 1967.

Shhhhhhh!

LOL..

 

[Suregrip391]

I just may have one already then! I know I have a couple floating around from my 1970. I will check it out and post a number if it’s on it….thanks!

 

[GTS Dean]

Your car's grommet has a plastic n ipple inside it to connect an extension hose to the pcv valve. Otherwise, it is standard Mopar. Pop the old grommet out, cut it to get at the n ipple and swap it to the new one. In the photo below, I was tinkering with a larger vent hose idea.

 

[Suregrip391]

Cool, thanks Dean! I’ll need to find a mopar number for this.

 

[BoremViper97]

I recently was dealing with the same thing regarding the 90 degree n ipple at the from of my driver side valve cover.
I even contacted Dorman and they don’t have anything with 1/2” female on both sides.
Anyone here have an idea for me?

 

[GTS Dean]

Your Dodge dealer can still get this entire assembly for about $20.

 

[BoremViper97]

Your Dodge dealer can still get this entire assembly for about $20.

do you have the part number? or a good web site that i could shop? (you seem like you may lol)

 

[GTS Dean]

Tag says:0476 3806 AC

 

[ISMarco]

I found a NAPA P/N that fit on mine (The grommet that goes in the hole in the engine only, no hose barb included):

Napa 630-1039 PCV Grommet

 

[GTS Dean]

Have you put the intake on yet? Hold off if you haven't and check your PM s.

 

[BoremViper97]

I found a NAPA P/N that fit on mine (The grommet that goes in the hole in the engine only, no hose barb included):

Napa 630-1039 PCV Grommet

This may be what everyone else is talking about, but not what I need.
I need a 90 degree elbow.
Yours is this:

 

[GTS Dean]

Dorman products sells the formed hose from the n ipple to the manifold tee.