Power brake bleeder

[94RT10Ohio]

Who has a power brake bleeder that works with the Viper and where did you get it? I want to flush my fluid this winter and do not want to take it in to get it done.

 

[FrankBarba]

Contact your local Snap On Dealer. Nice hookup.

 

[RoadiJeff]

I had pretty good luck recently with a $5 one man brake bleeder kit from AutoZone. It basically consists of a plastic bottle with a one-way valve, some fittings and plastic hose.

You connect everything, mount the bottle to something metal on the car (comes with a magnet mount) that is higher than the caliper (air bubbles) and slowly pump the brake pedal 4-5 times. Drain the bottle and pump a few more times until clear fluid runs through the hose.

The first wheel took about 10 pumps and the others gradually were less. Brakes work fine, new fluid throughout and I did it myself without a lot of costly equipment.

 

[Copernicus]

The Motive bleeder is a good solution.

Check this thread for some more details.

http://www4.forum.viperclub.org/showflat...true#Post544171

 

[jcaspar1]

The Motive is great but the universal adapter *****. The adapter from Miller tools (part #6643a) is 56$. I have heard that the Ford three tab master cylinder cap fits the Gen II Vipers but have not confirmed that for sure.

 

[SteveMat]

I have the Motive Bleeder and bought the Ford 3 tabbed one (1106/7 - Ford Adapter) fits perfect, makes it a snap - http://www.motiveproducts.com.

 

[jcaspar1]

That's what I needed. I'm ordering the Ford adapter!

 

[95Viper]

Careful....the Ford3 prong only fits non-ABS Vipers.

 

[JiPi]

Anyone know which adapter fits the clutch reservoir?