Springs and caps on 345/35/18 drag radials?

[Junkie]

Is anyone running that low on drag radials? I've got 345/35/18 M&H's with springs/caps and it rubs on bumps and heavy suspension load. The M&H supposedly runs .5" or so taller then the MT in the same size so I'm wondering if I can run the MT's without raising the car up.

You must be registered for see images attach

You must be registered for see images attach

 

[Raven2k8]

With a stiffer setup from coil overs you would probably be fine. I have the same tires with caps and I have rubbed only one time with two people in the car and some nasty dips in the freeway. The stock suspension is just terrible. I will be getting some coilovers soon.

 

[98intrigue]

Is the ebrake relocation kit needed to run 18s in the rear?

 

[hyph]

Is the ebrake relocation kit needed to run 18s in the rear?

Yes it is:

http://www.racingsolutions.com/prod...n-kit-for-dodge-viper-gen-3-4-2003-2010.html\

Is what I used.

 

[Junkie]

Yes it is:

http://www.racingsolutions.com/prod...n-kit-for-dodge-viper-gen-3-4-2003-2010.html\

Is what I used.

Same thing I did. Install was cake, works great.

 

[Tiago]

yes it will rub a lot on that setup... almost undrivable.

Get coil overs and adjust the ride height appropriately.