Where to place jack stands in rear of SRT10?

[johnk]

Do I need to remove the aluminum panel under the center/rear area of the car to access suitable frame points for 2 jackstands on an '06? Sending the wheels out for work and the car will be out of commission for a few weeks, will just raise the car on the 4 post lift, and set it down on stands. Thanks

 

[29OUTLAW]

When I did my e-brake relocate, I was able to get jackstands on the rear by just unbolting the back half of the sheet metal panel and letting it hang down. However, I had to completely remove the panel that the splitters attach to.

 

[johnk]

Thanks, you don't happen to own a white 'vert, do you?

Take care
John

 

[29OUTLAW]

Thanks, you don't happen to own a white 'vert, do you?

Take care
John

Nope - I'm a yellow vert that seldom travels beyond Lex Park, Calif, or Solomons.

 

[ViperBran]

I lifted the car one side at a time and had 2 wheels done at a time. Very easy.

 

[Rolstar]

In the cross members you will find holes where the jack stands need to be placed, bothe the front and rear.

 

[ViperTony]

Scroll down to Part II in this writeup: http://forums.viperclub.org/showthread.php?t=603840

 

[slaughterj]

Scroll down to Part II in this writeup: http://forums.viperclub.org/showthread.php?t=603840

That looks to be for a Gen 2. A Gen 3 rear section is significantly different and doesn't facilitate easy jacking from the rear, check underneath one and see.

 

[ViperTony]

Oops, sorry I thought I was in the GenII forum when I responded to this. I wish I had a GenIII so I can answer your question properly.