R134a AC gas capacity

[carlv12]

Hello,

I need to know the capacity of the R134a AC gas in a 3rd gen. Viper SRT10 from 2004.

I know that the service manual only states "Refer to the A/C Underhood Specification Label located in the engine compartment", but my Viper has a 2008 hood and I cannot check the label on my original hood. So please make a picture of the label and tell me the capacity.

Thank you and best regards from Valencia

Carlos

 

[AZTVR]

Sorry, I can't help with a specific answer. For refrigerant capacity, the service manual only states "Refer to the A/C Underhood Specification Label located in the engine compartment" and I don't have access to an SRT10.

 

[steve e]

If you can get a set of AC gauges, You don't need to know capacity, fill from the low side on till the high side is 150psi , that should be fine, if not cold enough add a little more, keep it under 200 psi.

 

[carlv12]

Hello again,

I know that the service manual only states "Refer to the A/C Underhood Specification Label located in the engine compartment", but my Viper has a 2008 hood and I cannot check the label on my original hood. So please make a picture of the label and tell me the capacity.

I hope you can help me, because here in Spain there are no other Viper's around to check.

Thank you

Regards from Valencia

Carlos

 

[AZTVR]

Hello again,

I know that the service manual only states "Refer to the A/C Underhood Specification Label located in the engine compartment", but my Viper has a 2008 hood and I cannot check the label on my original hood. So please make a picture of the label and tell me the capacity.

I don't have access to a 2004 Viper; but, I see in photos online that the label is not on the hood itself. It can be seen in the lower right corner of this photo from an eBay ad. Maybe someone can take a close up of one.

You must be registered for see images attach

 

[Steve-Indy]

Hi, Carlos:

The tag on our 2003 Viper says R-134A Factory Charge 0.454 kg ( 1.0 lbs.)