Seat Belt Mounting Hole on Transmission Tunnel

[dunce]

Been looking for the bolt hole on the transmission tunnel for the "inside" part of a 5 point harness.....been pokin' around with a needle.......(I could have disassembled the entire interior in the amount of time I have been poking around....but then again when I go fishing......I know going to Safeway would be quicker and has a 100% sucess rate).....

......anyone have a photo with the carpet removed (I need a fish finder)???

z

 

[GR8_ASP]

I ended up taking the carpet off on the passengers side because I could not locate it. Had the seats out also. No pics though.

 

[Flash1034]

Been looking for the bolt hole on the transmission tunnel for the "inside" part of a 5 point harness.....been pokin' around with a needle.......(I could have disassembled the entire interior in the amount of time I have been poking around....but then again when I go fishing......I know going to Safeway would be quicker and has a 100% sucess rate).....

......anyone have a photo with the carpet removed (I need a fish finder)???

z

Ironic that you posted this. I was just going to ask soemone to post the step by step instructions for the TeamTech 6 pt harness install on the SRT-10. Could someone please post it for fax me a copy of the install instructions? fax: 949 347-0109 or [email protected]

Please,

Flash

 

[TBarrow]

MIne already had a bolt in it so an Ice Pick would not do it. I will try to get some measurements from the floor and the back of the car.

 

[steve911]

My instructions came on a VHS tape. I have never heard of printed directions.

 

[dunce]

Hey...some measurement of where the center of the bolt is would be great. If you could measure from the rear floor "corner" going forward and then up. Thanks Mark

 

[Mike Dolan]

First off, you won't find a hole as there is a bolt in the hole, feel for a bolt head. Also check straight up a couple inches above the seat mounting stud and that's where it'll be.

Regards,
Mike Dolan

 

[Kai SRT10]

Make sure to take out the seat. It will save you lots of time.