It is a Fitzgerald Motorsports special edition as Carguy mentioned. Fitzgerald motors was located in NH. They built quite a few of these over the years. I believe they closed down the business a couple of years ago after Dan Fitzgerald retired. One of the board members on here that lives in PA...
Stretch,
The info you requested as been posted on the VCA Viper events and gatherings section on the forum. Read the sticky post by PAULS. This post should answer your?
Thanks for the Thursday invite but I maybe helping out with the weekend events that eve. I will pass the word around to the...
Tom,
Good to see you are going to make it. If you pre-registered through the OH. VCA you should be receiving a e-mail with the event schedule. The Friday cruise is set to start at 10AM from the Infirmary Mound Park which is almost in your backyard. I will be arriving on Thursday afternoon at the...
The Friday cruise is set to start at 10 am from the Infirmary Mound Park. The gates open at 8 am Friday morning at the track. Did you pre-register at the host motel Hyatt? If so they will have your credentials for the weekend at the check in desk. Lunch will be held at a Amish restuarant around...
Glad you are able to make it. Last i heard there were close to 40 cars pre-registered for the Friday road run. About another dozen or two waiting on the weather forecast. You can still show up Friday morning at the track and register for the Friday run and lunch. I am guessing the Woodward...
Alex,
Any suggestions for those of us trailering across the border? I have been across the border many times but never with a enclosed trailer in tow. Do you have to use the truck lane to go through customs? Thanks for any info.
Frank,:usa:
I will be arriving late Thursday afternoon with my 99 ACR. The Ohio VCA has been doing this event for a few years now. They have it very well organized. The track accomodations and food are first class. Your only regret will be not attending. Hope that you decide to make it.:usa:
I have purchased 6 of them over the years and had 2 of them go bad. It seemed to happen after getting them wet while driving in rain. I contacted the vendor and they replaced both of them with no issues.:usa:
I switched over to Amsoil in my 97. I was tired of having the shifter rattle return after only a few hundred miles with the oem lube changes. I have over 3K miles now on the Amsoil lube with no rattle issues and the trans shifts like butter as well.
Looking for a radio delete plate for my 99 ACR. Already checked with the Wizard. The plate has no part# meaning it can't be ordered from Dodge. Thank's for any help.
Sounds like you have the earlier designed hub with no split. I had my local NAPA store which has a full machine shop do all of mine. Takes about 10 mins. for them to r&r the hub. The back of the hub is gapped between .090'' - .100'' from the pump housing. As mentioned above install the pulley...
I have a set of 4 foot aluminum low profile ramps that attach to the end of my dove tail. The Vipers drive up on them with no scrapping issues at all. You can also pump your front tires up tp 50 psi. This will give you some added clearance as well. Just remember to deflate back down before...
Dave's suggests a .070'' - .100'' gap between the backside of the hub and the pump housing give or take .010''
I have done 5 of these so far and all 5 are the same as mentioned above which is the front of the hub being just over the start of the shaft and not dead flush with each other.
Brian, I believe the total count for all the blue 97 RT/10s was 53 as you listed. If I recall correct The 53 blue count also includes the one solid blue no stripe car built which leaves 52 blue and white striped RT cars built for 97. Again If I recall there were 64 red cars built including the...
As I mentioned i do not recall the exact added weight from the upgrade but believe it was around 20 lbs. You may want to post the question over on the ask the GRAILKEEPER forum. I am sure Herb can give you some more accurate info on the 08 production updates.:usa:
Re: 08-09 VIPERs (inc ACRs) at INVOICE 08 Viper Blue/Black Stripes Conv. 69995 30 mi
I had the same thought's on the new ZR-1. Was not a big fan of the car until today. I had the opportunity to see one in piece's at a well known Vette tuner's shop. The car is world class as for component's...
The 08's had a weight increase occurring between early and mid production. The added weight came from beefed up half shaft's being done on all model's. Cannot recall if the added weight was 20 lbs or 40 lbs per car. This added weight was not factored into the intial advertised weight of the 08's.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.