I have an xmetal TB on the shelf. It's not installed for 2 reasons.
1 - is stupid, I keep thinking about the ROE SC setup & think why install if I hope to go this route next year (may be a pipe dream due to $)... duh, just take it off & sell it then.
2 - I remember reading a post or two about dyno'ing after install & dropping a few ponies. Does anyone have experience on before & after results?
I'm thinking of doing a VCA dyno day on Sunday & can't help thinking it'd be cool to do a pull or 2 & then install it and pull again. Of course, I have to go thru the instructions again to see if that's plausible time wise, etc. Love to hear others' thoughts, findings.
Dave.
1 - is stupid, I keep thinking about the ROE SC setup & think why install if I hope to go this route next year (may be a pipe dream due to $)... duh, just take it off & sell it then.
2 - I remember reading a post or two about dyno'ing after install & dropping a few ponies. Does anyone have experience on before & after results?
I'm thinking of doing a VCA dyno day on Sunday & can't help thinking it'd be cool to do a pull or 2 & then install it and pull again. Of course, I have to go thru the instructions again to see if that's plausible time wise, etc. Love to hear others' thoughts, findings.
Dave.