Search results

  1. R

    Corsa cat back install

    Go For It!! One suggestion - well maybe 2. 1. Take the side sills off and soak all the clamps to be removed with liquid wrench or equivalent, perhaps overnight. 2. When putting the new rear muffler section in place with the exhaust tips through the hole; it is a VERY tight fit (at least it...
  2. R

    New Viper Coupe in Car & Driver 253mph

    October 3, Autoweek - same car only cranks out 987 HP, $1.2 million, and you can go from LA to New York in 11 hours and 9 minutes - oh, that's at 250 mph. Good Luck.
  3. R

    help! alarm tripped

    Next time use this: From JCWhitney: http://www.jcwhitney.com/autoparts/Search?catalogId=10101&storeId=10101&sku=ZX818203U&searchbtn.x=8&searchbtn.y=11 I actually got mine from NAPA (close to my house), Part #BK 7821609 (295A) I used this while changing a battery, so as not to...
  4. R

    My Fan is Causing My High Idle

    Go to the following link and read the complete article: http://www.caraudiomag.com/testreports/0401cae_hyper/index.html I have this on all my cars, including the Viper. I ran into this at a car audio/stero place, that installs high power sound systems. Don't worry too much about the increase...
  5. R

    How much stress does a dyno put on a car ?

    I don't/can't do the pull: I DON'T Dyno, pure and simple. Later,
  6. R

    Viper on top in T-1 SCCA Runoffs Qualifing!!!!!!!!!!! Go Scotty White

    The run-offs are this week/weekend, and SPEED TV issued the press release below about how important the run-offs are, etc., etc., etc......, yet we will see the T1 race on Sat. Nov. 26 at 2:00 eastern time(1 month after the fact), and the races stretch out through Dec. till Jan. 1. Seems their...
  7. R

    17's >>>>18's

    Re: 17\'s >>>>18\'s Minor difference; use the following to calculate the actual tire diameter: ********************************************* TIRE DIAMETER CALCULATION Tire Diameter = (Width x Aspect Ratio) / 2540 x 2 + Wheel Diameter(inches) Where: Width is the first number in size (i.e...
  8. R

    Drag - proper burnout tips?

    If you have tread on the front tires, pull around the water, and BACK in if you are going to do a water burn out. Now I have never used a line lock or used the brakes in the water. If you are in the water, do a 2nd gear burn out and as the car moves out of the water, stay in it until the good...
  9. R

    Plugs for Gen1 engine - Champion RC12LYC or RC12ECC ???

    Brian, I use, and always have, Champion #412 (RC12LYC). Gap at .032 - .033" Gives good spark at high RPM. Don't know how many miles you drive a year, but I change mine every year (2000 - 3000 miles) whether they need it or not; includes some track days. Later,
  10. R

    What Does Detonation Sound Like???

    If you can hear it, you are definitely doing damage!!!!! Even if you can't hear it damage is being done - get it fixed !!! Later,
  11. R

    WOW MUST SEE GREAT DEAL

    It's only 2 wheel drive. :confused: :confused: $32K, not possible - misprint perhaps??
  12. R

    using a buffer

    Use what the pros use: http://www.rightlook.com/ I have seen these products in professional detail shops. I have been using these products, and was asked this past weekend what I use on the car; this was at a car show where "show and shine" is the ultimate. Later,
  13. R

    BEST picture of your Viper post

    Taken from Alki point (beach) with Seattle Space Needle in background: :usa:
  14. R

    Newbie looking for a Viper

    Check the classified, above, lots of 01 and 02 Vipers.
  15. R

    Differences in GEN 1 OEM Windows?

    I spent part of yesterday calling numerous Auto Glass places to replace my windshield ('96 RT/10). One told me the part number for ALL RT/10's (convertibles), 1993 - 2002 are the same. I'm sure a call to Dodge could verify this. Later,
  16. R

    How do I post a video of my new Twin Turbo on the dyno?

    Upload here: http://www.savefile.com/ Totally FREE and up to 60mb per file
  17. R

    Roll bar camera mounts?

    Here are some mount ideas, not sure if any would be adaptable for you - take a look: Check this out; a suction cup type mount that might adapt somewhere. http://www.stickypod.com/products.htm?OVRAW=Auto%20camera%20mount&OVKEY=camera%20mount&OVMTC=advanced This would be trick, but not...
  18. R

    3:55's v's 3:73's

    Re: 3:55\'s v\'s 3:73\'s PhoenixGTS and ALL, Gear Calculator...
  19. R

    Orange GTS Viper picture please post again

    One or these was photoshopped; look at the shadows on the car, they are identical; the car is parked in EXACTLY the same place, etc. etc. etc. Still good pictures.
  20. R

    Floor Jack

    Save yourself all the grief of will the jack fit or not, and drive up onto a couple of 2 x 8, or 2 x 10, and then jack the car; very simple. Later,
  21. R

    FINALLY Found the problem, BAD Engine mount! Typical ??

    2002 Viper..... I agree; vibration and noise would be horrendous, for anything other than pure drag racing. Why don't you contact Sean Roe for motor mounts, perhaps additional input might lead to something. Reference (copy) the email I included above if you like. Later,
  22. R

    FINALLY Found the problem, BAD Engine mount! Typical ??

    2002 Viper ......., Here is a Email I sent to Sean Roe about motor mounts, note the date; June 2003: ************************* Hi Don, Yuk, those motor mounts look bad. I'll see what I can do for new ones. Regards, Sean On Mon, 16 Jun 2003 12:19:49 -0700 "Don" <[email protected]&gt...
  23. R

    http://www.mopar.com/pdf/viper/00sr.PDF

    Re: http://www.mopar.com/pdf/viper/00sr.PDF http://www.mopar.com/viper.html
  24. R

    Viper vs all on the Road Course

    360, Enzo, and me ('96 Viper RT/10) www.nickdiaz.com/transfer/don/EnzoFerrari_Pacific_Raceway_6805_Narrated.wmv

Latest posts

Members online

Forum statistics

Threads
153,644
Posts
1,685,209
Members
18,220
Latest member
ROIII
Top