Search results

  1. R

    Water Pump - how good is a new one?

    Thanks Alan, That was/is my intent, when I get to it. Later,
  2. R

    Water Pump - how good is a new one?

    Yes, Gen 1. Am leaving town for 2 weeks, will resolve this later in July. Thanks.
  3. R

    Water Pump - how good is a new one?

    I think we have diagnosed that I have a bad water pump. I did a search and found many of the same symptoms I have. I also see where many have replaced the water pump, and the problem is solved. My question is are the replacement pumps "better" and failure is not an issue?; or are there...
  4. R

    Where can I purchase a service manual? ('97 GTS)

    Re: Where can I purchase a service manual? (\'97 GTS) Try Ebay, sometimes you get lucky, got mine there years ago.
  5. R

    Latch on removable hard top..

    jbs45, What year is your hard top? I suspect it is newer than mine (1996), and may be very different. I just went and looked at mine, and there are no springs. The latch rotates from side to side freely (no spring), with just rubbing friction. The plate where you slide the latch has a detent...
  6. R

    Latch on removable hard top..

    Huuummmmmmm, What year?, and maybe it makes no difference. The 2 Phillips head screws that hold the latch in the top, should have fallen into your lap if the top was on the car, not into the top. I just fixed mine as the latch became loose and the top would vibrate and unlock itself from one...
  7. R

    C6 ZO6 VS GEN I Viper at HPT Roadcourse

    Better Driver or Better Driver - Take a look. Video is narrated http://videos.streetfire.net/Player.aspx?fileid=B0D1560A-CDDC-4E5F-8447-062C1583A203 or http://www.youtube.com/watch?v=JeTdFvtiTuA Later,
  8. R

    Header question

    Probably not; but do not know for sure. Probably some who have done extensive Dyno tuning could say for sure. Later,
  9. R

    Header question

    Click the "Photos" link below my avatar, and the first 2 pictures showing '98 tube headers will show you all you need to know about fitting Gen 2 tube headers to a Gen 1. Well almost; You need to have the Gen 2 flex pipe section in order to clamp the header to the flex pipe section, and you...
  10. R

    Clearance upfront

    4 in to the 3/8 in lip that hangs down at the back of the facia. 4 3/8 in. to the lowest point of the facia itself. 1996 RT/10
  11. R

    GARAGE FLOOR HELP!!!

    USAF Viper, Check out the pictures of "Garage Floor...", in my photo gallery. I have had this floor for 4 years now and it serves well. Available from Sam's Club, as well as other places. Click on the 26 Photos link under my Avatar Later,
  12. R

    My Battery is dead ! What to buy? Are Optimas worth it? and do they fit ?

    Steve, You are probably correct, I just read the MTP from the invoice, it was a side post only. I didn't look at the battery - a little hard to see, as you know. At any rate it is a good battery, and fits with no "post" interference (side post only). Later,
  13. R

    My Battery is dead ! What to buy? Are Optimas worth it? and do they fit ?

    Interstate: MTP-78, 85 month, about $90.00 I replaced the original (1996) battery with this one in August of 2005. OH, DEFINITELY a Battery Tender. Later,
  14. R

    NOW THAT I'M OUT OF WARRANTY,BEST OIL/FILTER TO USE

    Re: NOW THAT I\'M OUT OF WARRANTY,BEST OIL/FILTER TO USE Make your own decision: http://minimopar.knizefamily.net/oilfilterstudy I use WIX (51085 for Viper), on all my cars. Later,
  15. R

    What Does Your Personalized Plate Say?

    Mine: VIPURR My EX son in Law: GUN4HIRE
  16. R

    Replacing Brake Pads......Have a couple of questions.

    You do not need to remove the rear calipers, I repeat, YOU DO NOT NEED TO REMOVE THE REAR CALIPERS. Remove the pins, noise spring, and pads. Remove the rotor - you may need to rotate the hub to get the wheel studs in the correct position for the rotor to come off. Screw in the piston as...
  17. R

    Free to good home

    Peter, Thank You, Thank You, Thank You. You are welcome here anytime. Have a good life back home. Later.
  18. R

    Free to good home

    Peter, You have a PM.
  19. R

    Help, wiper problem

    GTSJERRY, I have the same problem, herky, jerky passenger side motor. I have a replacement driver's side motor sitting on the bench; haven't gotten around to installing it yet. Are you saying a new DRIVER'S side motor did not fix the problem? Later,
  20. R

    A couple of Backrounds for your desk/laptops.

    This is not Photoshop - This is real ! :2tu: View movie here: http://videos.streetfire.net/Player.aspx?fileid=B0D1560A-CDDC-4E5F-8447-062C1583A203 Later,
  21. R

    Anyone Have A High Quality Picture Of A Viper Emblem???

    Email on the way with pics. Later,
  22. R

    Intake differences, some ‘94s are freaks…help!

    Craig, Your statement is correct, but might be a little confusing. ALL Gen 1's is correct including the 96 Gen1 (RT/10) The 96 Gen2 had the metal ones; and all subsequent Vipers. 1996 GEN1 (RT/10) PRODUCTION VIN #'s First VIN: TV100001 Last VIN: TV10780 Total Production: 721 My...
  23. R

    Looking for door pieces or part #'s in the door jam

    Re: Looking for door pieces or part #\'s in the door jam Domenic, You have a email
  24. R

    Blue-White RT/10

    RedEnuf93 Check out the photos in my Photo Gallery Primarily Page 2. Later.
  25. R

    An interesting site for us track day guys.

    InjectTheVenom, Yes, that is a direct link, as is the 2nd link listed below from my posting directly to Google. http://video.google.com/videoplay?docid=4879177441216220642&q=Pacific+Raceway http://video.google.com/videoplay?docid=4879177441216220642&q=Enzo John (jstecher), Thanks for...

Latest posts

Members online

Total: 1,348 (members: 1, guests: 1,347)

Forum statistics

Threads
153,644
Posts
1,685,209
Members
18,220
Latest member
ROIII

Share this page

Top